Sorry, you need a Java-enabled browser to see the simulation.  

This is a demonstration of an PNP transistor. The emitter is at +2V, and the base and collector voltages can be controlled using the sliders at right. Move the mouse over the transistor to see labels for the three terminals. Compare it to the NPN example.

The emitter-base junction acts like a diode. Unlike an NPN transistor, current flows out of the base, not into it. Little current flows out of the base unless it is below about 1.4V (0.6V below the emitter). Assuming the collector is at a lower voltage than the base, the emitter-collector current is 100 times the base current. So, this transistor has a beta (current gain) of 100. Moving the collector voltage higher or lower won't have any effect as long as it's lower than the base voltage. This is forward active mode.

A transistor is often considered to be in saturation mode when the collector is higher than the base. But it still acts like forward active mode unless the voltage difference, Vcb, is on the order of a diode drop (.6 V). If the base is at 1.3V and the collector is raised to about 1.86V or higher, the base current will go up and the collector current will go down, so it will no longer be 100 times the base current. This is saturation, where the transistor acts like a low-resistance switch, with a small voltage drop from the emitter to the collector.

Next: Switch
Previous: NPN Transistor (Bipolar)
Index







java@falstad.com
Generated Sat Nov 15 2014